Zed Link Quad (zed x one gmsl2 * 6) and ouster LiDAR Sync

[shpark98]

Thanks for your reply!!

The reply was really helpful, but I just wanted to confirm!

@Myzhar

You can split the cable to send the signal to the slave GMSL2 deserializer and to the external simultaneously.
Remember that in this case, you must also connect the GND signal to the external receiver to have the same signal voltage reference.

If I understand correctly, should I proceed with the wiring work like this?

@Myzhar

Please note that if the SINC_PULSE_IN of the Ouster requires a different voltage than the provided 3.3V, you need a voltage converter circuit too.

I’m sharing a document I found regarding sync_pulse_in on the Ouster LiDAR hardware.

In my perspective, everything looks fine, but do you see any potential issues related to the voltage you mentioned? I’m not very familiar with this area, so even though I checked it myself, I wanted to ask again to confirm from an expert’s perspective.

Thank you very much for your help!!