# Carrier board mini - cameras not detected

**URL:** <https://community.stereolabs.com/t/carrier-board-mini-cameras-not-detected/10924>\
**Category:** ZED X\
**Created:** [February 27, 2026, 8:55pm UTC](https://community.stereolabs.com/t/carrier-board-mini-cameras-not-detected/10924 "2026-02-27T20:55:50Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![andrwr\_rev](https://community.stereolabs.com/letter_avatar_proxy/v4/letter/a/e0b2c6/32.png) [@andrwr\_rev](https://community.stereolabs.com/u/andrwr_rev)\
**Post date:** [March 4, 2026, 4:10pm UTC](https://community.stereolabs.com/t/carrier-board-mini-cameras-not-detected/10924/6 "2026-03-04T16:10:23Z")

</div>

Ok, so we immediately ran into issues with running the OpenCV calibration tool in the containerized version ([this topic)](https://community.stereolabs.com/t/virtual-zed-x-one-calibration-fails-segmentation-fault/10953). As part of workaround attempts I installed the ZED SDK outside the container, and it immediately caused the same issues as in my original post. ZED\_Diagnostic fails with the log below.

[dmesg.log](https://community.stereolabs.com/uploads/short-url/vED4sdYRNRWFKU1ktqfiycZlv7X.log) (11.3 KB)

> [@Myzhar](#):
>
> If the Deepstream installer modifies the DTB setup, then you must reinstall the ZED X Driver to fix if.

Removing and reinstalling the driver and SDK does not solve the issue. That is, the Diagnostics will always fail until the carrier mini is flashed again. Please advise @Myzhar

---

_[View the full topic](https://community.stereolabs.com/t/carrier-board-mini-cameras-not-detected/10924)._
